Instructions Bear Magnet | The Atomic Bear

Instructions Bear Magnet

THE BEAR GUN MAGNET

INSTALLATION INSTRUCTIONS

IMPORTANT

Whenever you are using the 3M double sided tape, make sure to first clean the magnet surface and the receiving surface with rubbing alcohol (isopropanol) and a clean cloth. Then make sure to push on the magnet for at least 60 seconds when you are sticking it on the surface. Make sure that you get the right orientation, because once you start sticking it ain't coming off easily! Always test your installation for solidity before using the magnet to hold anything.

UNBOXING A QUICK LOOK AT WHAT IS IN THE BOX

Your powerful Gun Magnet
Four self-taping screws
One double-sided 3M install tape
Two PVC stickers

LEARN HOW YOU CAN INSTALL YOUR BEAR MAGNET GUN MOUNT UNDER A WOODEN TABLE

You will need rubbing alcohol (isopropanol) and a cloth
Two versions without drilling holes and using the screws
5/64th drill bit (or similar)

LEARN HOW TO INSTALL YOUR BEAR MAGNET ON DRYWALL

Your will need rubbing alcohol (isopropanol) and a closth
You will need 4 drywall plugs, 4 longer screws to fit your plugs
A drill and a 5/32 drill bit (chose a size that match your plug size)

INSTALLING YOUR GUN MAGNET ON A WOODEN DOOR FRAME

Get your drill ready with a 5/64th bit (drilling first is recommended, but if not, be careful to prevent stripping your screw head
Get your Phillips screwdriver with the content of the box

LEARN HOW TO INSTALL YOUR BEAR MAGNET IN A WOODEN DESK

You will need rubbing alcohol (isopropanol) and a cloth
I present only the version without drilling holes

INSTALLING THE BEAR GUN MAGNET IN YOUR VEHICLE USING THE 3M TAPE ONLY

Again, using rubbing alcohol (isopropanol solution) and a clean cloth
Make sure to properly locate the area where you want to install your mount
Verify that this location is comfortable and practical
Clean the surfaces with rubbing alcohol, let it dry for about 1 minute
Stick the tape on the magnet first, remove the second tape and stick it to the car surface
Hold it firmly in place for 60 seconds
Test your installation for solidity. If your car surface does not adhere well with the tape, you might be forced to use the screws